ABC 7/8" Wide Rib - VistaVent® Panel Fit

• Eliminates condensation
• Reduces utility bills through added attic ventilation
• Prevents moisture, pests and dust from entering the structure
• Fits any ridge cap
• Custom cut profiles to fit most panels
• One person installation
• Two beads industrial strength adhesive
• No fiber debris in packages
• No installation hardware required
• Flame spread passes criteria for HB classification, Appendix 1 of ASTM D635

Panel Fit venting material for metal panel roof hip & ridge 

Installation–Panel Fit

Step 1 Make sure panel is free of dust and debris. If not pre-cut, cut 2" slot at ridge. Measure and mark where the ridge cap will sit on the panel.

Step 2 Start from the end of the ridge, installing VistaVent venting material along the length of the ridge (both sides), making sure the bottom edge of the venting is 1/2"–1" up-slope from the edge of the ridge cap.

Step 3 When attaching consecutive ridge vents, butt fit the pieces together. Sealant can be used to seal the butt joint. Place ridge cap over ridge vent. Secure in place with fasteners; fasten through the metal roof rib locations, using an appropriate screw gun.