2.67 x 7/8" Corrugated - VistaVent® Panel Fit
Item No. 1549906
2.67 x 7/8" Corrugated - VistaVent® Panel Fit Eliminates condensation Reduces utility bills through added attic ventilation Prevents moisture, pests and dust from entering the structure Fits any ridge cap Custom cut profiles to fit most panels One person installation Two beads
Read full description
Description
Description
2.67 x 7/8" Corrugated - VistaVent® Panel Fit
- Eliminates condensation
- Reduces utility bills through added attic ventilation
- Prevents moisture, pests and dust from entering the structure
- Fits any ridge cap
- Custom cut profiles to fit most panels
- One person installation
- Two beads industrial strength adhesive
- No fiber debris in packages
- No installation hardware required
- Flame spread passes criteria for HB classification, Appendix 1 of ASTM D635
Panel Fit venting material for metal panel roof hip & ridge
Installation–Panel Fit
Step 1 Make sure panel is free of dust and debris. If not pre-cut, cut 2" slot at ridge. Measure and mark where the ridge cap will sit on the panel.
Step 2 Start from the end of the ridge, installing VistaVent venting material along the length of the ridge (both sides), making sure the bottom edge of the venting is 1/2"–1" up-slope from the edge of the ridge cap.
Step 3 When attaching consecutive ridge vents, butt fit the pieces together. Sealant can be used to seal the butt joint. Place ridge cap over ridge vent. Secure in place with fasteners; fasten through the metal roof rib locations, using an appropriate screw gun.
71834877-9a1e-4ca5-bf46-11b718d8647a
964f05d9-7c42-4c17-95ea-52d7aef82f4a
95aca51a-e1f5-4018-bbee-6b6f8da4e286
Product overview document
VistaVent data sheet
Vistavent
Specifications
Specifications
Product Type
VistaVent® Panel Fit
Material
Polyester fiber
Pitch
2-11/16" (2.67")
Rib Height
7/8" (0.875")
Rib Width Bottom
0"
Rib Width Top
0"
Attachments
Attachments