ABC 7/8" Wide Rib - ProfileVent® Panel Fit

• Limited lifetime warranty
• Design passes Dade Count 110 mph wind-driven rain test
• Reduces utility bills through added attic ventilation
• Prevents moisture, pests and dust from entering the structure
• Fits any ridge cap
• Custom cut profiles to fit most panels
• One person installation
• Glue spots prevent slipping during installation
• Will not sustain a flame – class A fire rating
• No fiber debris in packages
• Fits any pitch 2:12 – 20:12
• Meets all model building codes

• Ridge vent ventilation material
• New or re-roof on purlin or wood deck construction
• Anchor clips are recommended in high wind areas and on panels with major ribs 16" on center or greater

Installation–Panel Fit

Use a 2" opening at the ridge to provide ventilation. On new or re-roof wood deck construction, cut a 2" slot at the ridge (1" each side, start cut 6" from gable ends). On purlin construction position panels to leave a 2" opening

Step 1 Allow 2" opening at ridge for ventilation. ProfileVent® is positioned along the ridge, gable to gable, about 1/2" to 1" up-slope from the ridge cap edge. The positioning adhesive on most profiles will hold ProfileVent® in position and allow for repositioning.

Step 2 ProfileVent® can be cut with scissors or utility knife. When splicing ProfileVent®, make the splice at the center top of the high rib and use caulk or sealant along the splice

Step 3 Screw through ridge cap and top of each anchor clip (if applicable). Blind rivets can be used to anchor the ridge cap when using architectural or standing seam panels.